Meet Nitro and PRODEX 53 at IDS Cologne, March 16–20, 2027
DENTMATE CURING SOLUTIONS
Curing for the lab and the chair.
Find your right fit.
LED post‑curing machines for 3D‑printed dental parts, LEDEX™ curing lights for chairside work, and the Nitro nitrogen generator for a tack‑free finish — start with where you cure.
OUR PRODUCTS
Three product lines, one curing partner
Each line has its own page with every model, a side‑by‑side comparison and FAQ. Pick the one that matches your work.
Lab · 3D‑print post‑curing
LED Curing Machines
PRODEX™ & TRAYDEX™ — from a compact one‑touch unit to a touchscreen flagship with bottom light, pre‑heat and nitrogen pre‑gas.
5 models
35 – 300 W
- TRAYDEX 18 / 45
- PRODEX N2 / BL / 53
- Stable LEDs instead of UV tubes
Clinic · Chairside curing
LEDEX™ Dental Curing Lights
From a lightweight everyday light to Plasma output, broadband LEDs and built‑in caries detection.
6 models
Up to 3,200 mW/cm²
- WL‑070 / 070+ / 070+ ORTHO
- WL‑090 / 090+ / 120
- Broadband 390–480 nm
Lab · Nitrogen curing
PRODEX Nitro Nitrogen Generator
On‑demand nitrogen from your lab's compressed air, fed into the PRODEX 53 chamber automatically.
On demand
No gas cylinders
- Works with PRODEX 53
- Tack‑free, fully cured surfaces
- Runs on compressed air
WHICH ONE DO I NEED?
Start with what you do every day
IF YOU
3D‑print models, splints or restorations
Printed parts need a controlled post‑cure to reach their final properties. Choose an LED curing machine sized for your trays.
IF YOU
Place composites and bond at the chair
A LEDEX™ curing light gives you the output and wavelength range for everyday restorations, orthodontics and more.
IF YOU
Get tacky surfaces after post‑curing
Oxygen in the chamber stops the surface from curing fully. Nitro replaces it with nitrogen — paired with PRODEX 53.
